Altec 604 cabinet design considerations

[Altec Best]

Hello GM,

Thanks for the info. Just to clarify my understanding of your terminology - you are suggesting running a 30 degree chamfer bit around the outside face of the speaker cut out, and then easing the edges. The start of the chamfer would be at .707 of the depth, so for example on a 1" thick baffle, the chamfer would start at approximately .3" in from the inside face of the front baffle, and extend outward at 30 degrees to the outer face.

regards -- Roger

My Altec 612C's came with that chamfered edge from the factory...